![]() I'm having a similar (the same?) issue with my sync box. The whole setup is currently an extremely expensive HDMI switch, having replaced one that cost £15. If there's a different factory reset method you used I'd love to hear it. It feels very much like coincidence though, given when I set this up first time around it was my standard router setup. Naturally I tried turning 5GHz off again and got scenario 1 again and again 'til I gave up, very frustrated. I finally turned 5GHz back on to use with other devices and on a whim tried it after a couple of hours. I've read a bunch about WiFi network bands impacting the process, so disabled my 5GHz band for a couple of hours whilst I tried to connect. It connected fine but took me back to square 1. and no matter how long I left it held in after the green flash the unit would just go into standby (red light) mode and the app wouldn't find it. I got to the point you need to hold the power button 'til it flashes green then let go. ![]() When you say you factory reset it, do you mean you deleted it in the app then held the power button for ~15 seconds until it flashed blue? I've done that today 'til I was blue in the face (no pun intended) and subsequently gave up. Little orange notification icon, little orange message where the input select drop-down would be. ![]() Well, I tell a lie, it does find the bridge and when I press the button it momentarily says it's all good and then immediately loses connection again. It's been flawless for ~6 months now and after a router reboot a few days ago can't find the bridge. Click to expand.I'm having a similar (the same?) issue with my sync box. ![]()
0 Comments
Leave a Reply. |